Image Minder Flash Back 600
Mounting & Operating
Thank you for choosing the IMAGE MINDER BACK FLASH
unit for your dental & medical photography. These instructions provide
you with the basic setup and utilization of the light unit.
IMPORTANT! Please inspect packaging of the
Image Minder Back
Flash Unit for any shipping damage. If it is damaged contact
- Remove the Image
Minder Back Flash Unit from the shipping
- Remove the Plexiglas that is taped to the back
of the unit. This is to be inserted on the front later.
- Carefully remove the protective brown sticky
paper from the Plexiglas.
aluminum strips on the top and bottom of the box.
Turn the strips
over so the mounting holes are visible. Then screw them to the unit
with the small screws provided.
Look for an
available electrical power source. Mount the unit near the power
source with the screws and plastic anchors provided. We recommend
mounting the unit 30" from the floor to the bottom of the unit.
Also make sure to have approximately 7' of unobstructed clearance in
front of the unit. (See diagram.)
Screw the slave
strobe light into the socket. The delay trigger has a 9v battery
inside which should be changed every six months. The delay trigger
can lay in the bottom of the box.
Plexiglas down the grooves on the front of the unit.
- Different people have different heights. We
suggest using an adjustable stool to accommodate adults and
- The slave strobe charges as soon as you turn
on the front power switch. A recharge time of about 5-7 seconds
will be needed between flash shots.
- The person should be sitting on the stool
approximately 1 - 1.5 feet from the unit to get the best results.
Send an e-mail to the webmaster with questions or comments about this web
August 06, 2006
Copyright © 2006 PhotodentUSA